Recording takes
Record, stop, and record again.
After calibration, everyone spreads out to where they will record from, and the host's phone shows the recording screen.

Record
- The host taps Record, in the bar along the bottom, to start every phone together, and Stop — the same button, now red — to end the take.
- The other phones show Recording — the host will stop it while it runs.
- Each phone's level meter shows what it is hearing. Check that every phone's meter moves before you start.
Every Record and Stop makes a new take. Record as many as you like; each is kept separately.
Watching the phones

Under Phones, each phone is a small tile: its name, a dot for its sync, and its level. A crown marks the host and a star marks the primary phone. After a handover the crown moves to the new host; the star stays where it was until you change the primary.
- Trouble comes first. Phones are ordered by what needs attention, so the one to look at is at the top: a phone that has dropped out, one that isn't synced, one that is clipping, running hot, low on storage or battery, or merely loud. A tile shows at most one line — the most urgent thing wrong with that phone — and nothing at all when it is fine.
- The level has a thin marker riding ahead of it, showing the recent peak. It turns red for a peak that clipped. A loud band can clip on its peaks long before the level looks full.
Which microphone a phone is using, its free storage and its battery are shown in the lobby and on the calibrate screen, where there is room for the full list.
If a phone loses the host
During a take, a phone at the edge of range holds on to the host through a fade — somebody walking between them, or a moment around a corner — for up to half a minute before it counts as lost. Between takes, a phone that has gone is noticed within a few seconds.
A phone that goes out of range keeps recording. It shows Lost contact with the host at the top of its screen and keeps trying to reconnect. During a take it tries every second, and it calls the host straight back at the address it last reached it on, without waiting to see the session again first. If it still can't reach the host but can reach another phone in the session, it links through that one — see Before everyone spreads out. Move it closer to the host and keep StakdTrax open on it. If it doesn't find its way back, tap Reconnect to start the search over.
Range depends on what's between the phones. Put the host in the middle of the group rather than at one end, and keep phones out of pockets and away from bodies, which soak up Wi-Fi. Where there's a Wi-Fi network covering the whole space — the hall's, or a small travel router in the middle — join every phone to it: it reaches much further than the phones reach each other.
Once it's back, it catches up with the host — including a take that started or stopped while it was away — and tells the host about everything it recorded, so its takes are collected with everyone else's. This works until the host finishes collecting.
A phone that was away while the host stopped and started new takes went on recording the take it lost contact in, so its track for that take runs on through the others. When the session ends, the host cuts that track at the later takes' starts and ends, and puts each part into the take it belongs to — joined onto the front of the take it came back in, if it came back partway through one. The time between takes is left out. Home says which takes it went into; build their stacks again to include it. In Your recordings, a track fitted this way says carried on from the take it was recorded in, and a take that still has one that ran on offers Fit to the takes.
If it doesn't come back
A phone that has lost the host is still recording, and the host is not there to stop it. Tap Stop recording on this phone in the Lost contact with the host box. What it recorded is kept — only the host can stop the band's take while the host is actually there, so this button appears only once contact is lost.
Sending a take later
A take that never reached the host isn't lost. The next time that phone is in a session with the same host — the next practice will do — its lobby lists it under Takes still to send, with the session it came from and how big it is. Tap Send, and it goes back into that session's package on the host.
The phone checks with the host first, so the list only shows takes the host really doesn't have — it can take a moment to appear after joining.
If the host has deleted the session a take belongs to, there's nowhere for it to go, so it's listed separately under The host no longer has these sessions. The take is still on this phone, in Recordings. Tap the share button to keep a copy somewhere else, or Stop offering to take it off the list — the recording itself isn't deleted.
The host is then told the take arrived, and can open that session in Your recordings and build its stack again to include it. A late track lines up exactly as it would have on the night: everything needed to place it — its clock, its sample rate, where the calibration sweep landed — travels with it.
If the host has split that take since, the late track is cut at the same moments as the others were, and each part goes into the take it belongs to. Anything the split left out is left out of it too. The host is told which takes it went into.
A take stops being offered once it has been sent. If a take never got sent and the phones never meet again, the recording is still on that phone and can be shared from the Files app under StakdTrax.
When you're done
The host taps Finish and collect to gather every phone's recordings — see Collecting and stacking.
End, at the top of the screen, leaves the session straight away. A take in progress is stopped and kept, but recordings still on the other phones are not collected.